IBM Enterprise Server H80 Series - Manual (Page 36)

Emergency Eject
Note: Execute the following procedure only in an emergency (such as when the
tray will not eject even though you have pressed the unload button).
1. Insert a small diameter rod, such as a straightened paper clip, into the
emergency eject hole. (Refer to the illustration below for the location of the
emergency eject hole.)
2. Push in the tool until you feel resistance.
3. Maintain a small amount of pressure on the rod while pulling on the tray with
your fingernail.
4. Pull the tray open and remove the disc.
Note: Normally the tray makes a ratcheting sound when you pull it open using the
above procedure.
1 Headphone Jack 4 Tray Opening
2 Volume Control 5 Emergency Eject Button
3 Status Light 6 Load/Unload Button
20 RS/6000 Enterprise Server Model H80 Series User's Guide