Integra DTR-10.5 - Manual (Page 55)

55
Operations
Connecting the Power/Basic Operations —Continued
Using the Sleep Timer (remote controller only)
With the sleep timer you can set the DTR-10.5 so that it
automatically turns off after a set period.
Temporarily Changing the Speaker Output
Levels (remote controller only)
To change the individual speaker volumes temporarily,
follow the procedure given below. Each channel can be
set between –12 and +12 decibels (between –15 and
+12 decibels for the subwoofer). Note that the speaker
volumes will return to the original settings when the
DTR-10.5 is put in the standby state.
Note:
You cannot select a speaker if it is set to “Not Used” in
the Speaker Configuration Sub-menu of the Speaker/
Output Setup Menu.
Press the scroll wheel, and then
press the [Sleep] button repeat-
edly to select the required sleep
time.
You can set the sleep time from 90 to 10
minutes in 10 minute increments.
The [SLEEP] indicator appears on the
display when the sleep timer has been
set, as shown. The specified sleep time
appears on the display for about five
seconds, then the previous display
reappears.
Note:
If you are using the remote zone (Zone 2
or 3), it will turn off at the same time as
the main zone.
To cancel the sleep timer, press the
[Sleep] button repeatedly until the
[SLEEP] indicator disappears.
To check the remaining sleep time,
press the [Sleep] button. Note that if you
press the [Sleep] button while the sleep
time is being displayed, you’ll shorten
the sleep time by 10 minutes.
Caps Delete Language Loca t ion
Album Ar tist Genre Playlist
Repeat Video Music Photo
Display
Dimmer
T V Input
Sleep
Random Main A Main B
Muting
Angle Subtitle Audio
Memory Search A-B Repeat
Exit Gu id e
Rec
Last Memory
Prev
CH
Enter
Set up Retu
rn
Test Tone CH SEL
Pure A
Surround
Direct
Stereo
Re-EQ
THX All CH ST
Level + Level -
L Night Audio SEL
DSP DSP
To p M enu Men
u
VOL CH
Disc
+
-
Zone 2
Input Mode
Macro
Se rve r Aud io A D J
CH SEL Level –
Level +
Sleep
Scroll wheel
RC-556M
Sleep
Remote
controller
1 Press the scroll wheel to enter the
AMP mode.
2 Press the [CH SEL] button and
select the desired speaker.
3 Press the [Level –] or [Level +] but-
ton to adjust the volume level.
CH SEL
Level + Level -