Integra DTR-10.5 - Manual (Page 80)

80
Enjoying Net Audio —Continued
The music server settings can be made while you select
the music server as an input source.
Configuring the Music Server
1 Press the [Input] button, and
then roll the scroll wheel to select
MSRV.
Make sure that the “MSRV” is displayed
when you configure the music server.
2 Press the scroll wheel, and then
press the [Setup] button to display
the Main Menu.
3 Use the [ ]/[ ] buttons to select
“Input Setup,” then press the
[Enter] button.
ABC DEF
PQRS TUV WXYZ
GHI JKL MNO
@.-'/
--/--- Direct Tuning
#
Custom
Display
Dimmer
T V
Input
Sleep
Muting
On Standby
T V
T V CH
T V VOL
Exit Gu ide
Prev
CH
Enter
Set up Retu
rn
+10 0 Clear
1 2 3
4 5 6
7 8 9
Input
To p M enu Men
u
VOL CH
Disc
I
+
-
+
-
Zone 3
Zone 2
Input Mode
Macro
Se rve r Aud io A D J
Input
Setup
Enter,
/ / /
Scroll wheel
Input
Set
up
Enter
Enter
4 Use the [ ]/[ ] buttons to select
the “Music Server” sub-menu,
then press the [Enter] button.
The setup screen for the sub-menu
appears.
5 Use the [ ] and [ ] cursor but-
tons to select “Select Server” and
then use the [
] and [ ] cursor
buttons to select the desired
server.
Select a network server that exists on the
network.
* mark appears next to the servers
detected on the network. If there is a
server that does not have a * mark, make
sure that the server is running.
“Not Found” message indicates that no
server is currently available for selec-
tion. If the message appears, make sure
that the server is connected and running.
6 Press the [Setup] button.
This completes the configuration proce-
dure and the menu disappears.
Tips:
When choosing settings on the DTR-10.5,
after selecting the input source using the
input source buttons, press the [Setup]
button. Next, select the menu you want to
configure by turning the [Select/Preset]
dial and press the dial to confirm the
selection. Then, after selecting the sub-
menu you want to configure by turning
the [Select/Preset] dial, select your value
by turning the [Control/Tuning] dial, and
press the dial to confirm the value. If you
want to go back to the previous operation,
press the [Exit] button.
Enter
Enter
Enter
Set
up