Icom IC-718 - Manual (Page 33)

31
5
RECEIVE AND TRANSMIT
n Function for CW
ï Connection for CW
1 2 3 4 8 7 6 5 9 10 11 12 13
Paddle
[ELEC KEY]
[MICROPHONE]
See p. 32 for connection details:
Paddle operation from front panel
MIC connector.
Straight key
Microphone
Initial set mode setting (p. 45)
4
8
12
[ACC]
1 2 3
7 6 5
9 10 11
13
For no break-in operation:
Connect an external switch such as
a foot switch; or use the RTTY
SEND terminal for all bands.
(See p. 33)
: normal
: reverse
: off
: UP/DN key
ï CW operation
q Connect a paddle or straight key as above.
w Select CW (or CW-REV) mode with [MODE].
e Set CW break-in operation as semi break-in, full
break-in or OFF.
(See p. 42)
• Push [SET] for 1 sec. to enter quick set mode.
• Push [∫ UP]/[√ DN] one or more times until “BK–IN”
appears, then rotate the main dial to select the desired
condition:
FL: full break-in
SE: semi break-in
oF: no break-in
r Set the CW delay time when semi break-in
operation is selected. (See p. 43)
• Push [SET] for 1 sec. to enter quick set mode; push
[∫ UP]/[√ DN] one or more times until “BK–DELAY”
appears, then rotate the main dial to set the desired
delay time.
CW mode and semi
break-in operation
is selected.
Delay time of 6 dots
is selected in quick
set mode for semi
break-in operation.