Icom IC-718 - Manual (Page 43)

8
41
SET MODE
n General
Set mode is used for programming infrequently
changed values or conditions of functions. The IC-718
has 2 separate set modes: quick set mode and initial
set mode.
D Quick set mode operation
q While power is ON, push [SET] for 1 sec.
• Quick set mode is selected and one of its items appears.
w Push [UP Y] or [Z DN] to select the desired item.
e Rotate the main dial to set the values or conditions
for the selected item.
r Repeat w and e to set other items.
t To exit quick set mode, push [SET] momentarily.
D Initial set mode operation
q Push [POWER] for 1 sec. to turn power OFF.
w While pushing and holding [SET], push [POWER]
to turn power ON.
• Initial set mode is selected and one of its items appears.
e Push [UP Y] or [Z DN] to select the desired item.
r Rotate the main dial to set the values or conditions
for the selected item.
t Repeat e and r to set other items.
y To exit initial set mode, push [PWR] for 1 sec. to
turn power OFF.
u Push [PWR] to turn power ON again.
• The conditions selection in intial set mode are now
effective.
Item
Value of
Condition
Item
Value of
Condition
[DISPLAY EXAMPLE: INITIAL SET MODE]
[DISPLAY EXAMPLE: QUICK SET MODE]
[DIAL]
[ Z] [Y]
[SET]
[DIAL]
[PWR]
[ Z] [Y]
[SET]