Iomega 03798300 - Manual (Page 17)

17
Installation
Guide
Installing the Zip ® drive as the only
device on the secondary IDE channel
˾ IMPORTANT!
The Zip ® Internal drive uses the computer’s
onboard IDE/ATA interface. If you are not familiar with how devices
connect to the IDE interface, please see
Understanding IDE
Connections on pages 36 and 37.
˾
Change the jumper setting to “Master”.
The Zip Internal drive is set to the slave configuration as the factory default
at shipping. In order to connect the Zip Internal drive as the only device on
the secondary IDE channel, you will need to change the jumper setting on
the drive. The jumper is a small plastic piece that surrounds two pins. Use
the jumper provided and set it on the back of the Zip drive as shown in the
illustration below.
Jumper block
Master (Drive 0)
Locate a vacant 3 1 /
2
” or 5 1 /
4
” drive bay.
31/2" Bay
51/4" Bay
1
2