Iomega 03798300 - Manual (Page 22)

22
Installation
Guide
Check the following items before replacing the
computer cover:
PIN 1 on the IDE interface cable matches the PIN 1 connector on
your Zip
® Internal drive and the motherboard.
The IDE interface cable is securely connected to all pins on your Zip ®
drive.
An internal power supply cable from the computer has been connected
to your Zip
® drive.
Your Zip ® drive has been securely mounted to your computer.
Check all connections, arrange the cables to
fit under the cover, and replace the computer
cover.
Reconnect power cord, turn ON power switch,
and wait for the operating system to load.
Turn to the next page for instructions on
installing the Zip
® ATAPI driver and the
IomegaWare ™ software.
10
11
12
13