Iomega 03798300 - Manual (Page 42)

Tr
oubleshooting
42
You can’t change the drive letter assigned to your Zip ® drive.
Make sure BIOS support for the Zip ® Internal drive is disabled in the
computer’s CMOS setup. This may require turning off autodetection for
the Zip Internal drive. Refer to the Owner’s Manual for the computer if
you need instructions on getting into the CMOS setup and disabling
autodetection.
Zip ® disk won’t eject using Windows NT
If a disk does not eject from the Zip ® Internal drive, one of the following
suggestions should solve the problem:
(a) Close any windows listing the disk contents (such as My Computer or
Windows Explorer).
(b) The Iomega Zip ATAPI driver may not have loaded correctly. Try
reinstalling the driver following the instructions starting on page 23 of
this manual.
(c) If the disk still does not eject immediately, it may be due to the way
Windows NT handles disk caching. Eventually, NT will allow the
disk to eject.
Hard drive does not appear as an option in Copy Machine when
using Windows 3.1.
When using Copy Machine in Windows 3.1 or Windows for Workgroups
3.11, turn off 32-bit disk and/or file access. (This option is available when
changing virtual memory options under 386 Enhanced in the Windows
Control Panel). If 32-bit access is not turned off, your hard drive will not
appear for selection in the Copy Machine window.