IBM Print System QMS 4032 - Manual (Page 28)

8 
7




   
13
3
1 Turn off both the printer and the computer.
2 Connect the printer to the computer or network.

If you’re connecting to a computer through a parallel interface, see “Making a
Parallel Connection” on page 3-2.

If you’re connecting to the computer through a serial interface, see “Making a
Serial Connection” on page 3-4.

If you’re connecting to the computer through the Ethernet interface, see “Con-
necting to an Ethernet Network” on page 3-5.
» Note: If the printer is more than 6.5 feet (2 meters) from the computer, we
recommend using an Ethernet or serial connection for better communication.
3 Install a printer driver.
See “Drivers and Utilities” on page 3-7.
.




"#
$%    
Interface cables are not included with your printer. If you’re replacing a printer, you
may already have the necessary cables. If not, you’ll need to purchase the cables from
your QMS vendor or a local computer store.
To connect your printer to a single computer, you need a parallel cable with a 36-pin
male and a 25-pin male connector.
'( 
 
&&
& &
Your printer supports both Centronics parallel and IEEE 1284 bidirectional parallel
communications. The type of parallel cable you use depends on the type of parallel
communication your computer supports (check your computer user’s manual if you’re
unsure).