IBM Print System QMS 4032 - Manual (Page 32)

"

:  +7 4




   
1 Turn off the printer, and
unplug the power cord.
2 Connect one end of the
twisted-pair Ethernet cable
to the printer’s Ethernet port.
3 Connect the other end of the
cable to the 10BaseT/
100BaseTX concentrator.
4 Plug in the printer, and turn it
on.
' !

% 
If you’re controlling your printer over the network, CrownAdmin is recommended for its
ease of use. But it’s not necessary to do this right now. You can install CrownAdmin
software after the printer is up and printing.
For complete instructions, refer to the QMS CrownNet Setup Guide on the QMS Soft-
ware Utilities CD-ROM.
 %
'% 
This section briefly describes the ways to configure the CrownNet Ethernet printer
interface. For a complete discussion of all of the configuration options available through
the Administration/Communications/Resident NIC/CrownNet menu, see the QMS
CrownNet Setup Guide on the software utilities CD-ROM.
You can make these configuration changes through any of the following means:

Printer control panel—For information on using the printer control panel to
change configuration menu settings, refer to chapter 4, “Control Panel and Menu
Flowcharts,” of this manual or chapter 2, “Printer Configuration,” of the
Reference
manual.

CrownAdmin for DOS, CrownAdmin (for AIX, HP-UX, Macintosh, OS/2,
Solaris/SunOS, and Windows/Windows NT/Windows for Workgroups), or
CrownNet Manager (for OS/2)—For more information on using this software,
refer to the appropriate chapter in the QMS
CrownNet System Administrator’s
Guide or to the software’s on-line help.