Integra DPS-7.2 - Manual (Page 15)

15
SN 29343135 DPS-7.2E
Connecting to an Amplifier
(To Enjoy the Sound Advantage of the DVD Player)
Before connecting
• Refer to the instruction manual of the amplifier.
• When you connect the DVD Player to the amplifier, be sure to turn off
the power and unplug both units from the mains before making any
connections. Otherwise, the speakers may be damaged.
• Connect the plugs securely.
Notes
• The remote controller supplied with Integra/ONKYO amplifier can
be used to operate the DVD player.
• The function of the upper and lower z connectors are the same.
Connect to either one.
• When using the optical input jack, remove the protective cap and
keep it safely. When the jack is not used, replace the protective cap.
■ Making a digital connection with the
amplifier
If your amplifier has a digital input jack, be sure to connect
it to either DIGITAL OUTPUT OPTICAL or COAXIAL jack
on the DVD player.
Note
DO NOT connect to the AC-3RF input (e.g. of a Dolby Digital
receiver) which is reserved only for video disc players.
Although you can reproduce the DVD Player’s sound from the TV speakers with the connections on pages 13 and 14, connecting
with an amplifier provides you high quality dynamic sounds.
: Signal flow
Optical fiber connection cable
To digital optical jack
Incomplete
Insert completely
Audio connection cables
To audio inputs
BE sure to set the digital output setting after
connection using the Setup Navigator explained in
“Setting Up the Player” starting on page 17 or the
function setting menu explained in “Adjusting
Audio and Video Settings” starting on page 42.
FRONT SURR CENTER
SUB
WOOFER
AC INLET
Y P B P R
COMPONENT
VIDEO
S VIDEO
CH 1 CH 2
VIDEO OUTPUT ANALOG OUTPUT
L
R
CH1
CH2
RS-232
DVD AUDIO/VIDEO PLAYER
MODEL NO. DPS-7.2
OPTICAL COAXIAL
REMOTE
CONTROL
DIGITAL OUTPUT
z cable
To z jack
Coaxial connection cable
To digital coaxial jack
An amplifier with a Dolby
Digital/DTS/MPEG1/MPEG2
decoder
Making discrete 5.1 channel ANALOG
OUTPUT connections
The discrete ANALOG OUTPUT jacks are intended to deliver
up to 5.1 channels of multi channel audio from DVD-Video and
DVD-Audio sources. Connections can be made from the
ANALOG OUTPUT FRONT, SURR (surround), CENTER, and
SUBWOOFER jacks to the corresponding input jacks on an AV
component with multi channel discrete audio input jacks.
Note
To ensure proper delivery of sound, be sure to match the names of
the jacks on the DVD Player and the component being connected to.
An amplifier with 5.1
channel discrete input
DO NOT connect
the mains lead at
this time.
FRONT R
FRONT L
SURROUND L
SURROUND R
CENTER
SUBWOOFER
z cable
To z jack