Integra DPS-7.2 - Manual (Page 61)

61
SN 29343135 DPS-7.2E
Others
Pre-programming remote controller
Learning a pre-programming code
You can make RC-451DV remote controller to operate a TV
from other brand than Integra/ONKYO by storing the pre-
programming code of the brand in the RC-451DV.
Set the DVD/TV switch to TV.
Find the 2-digit number for the brand
name of the component that you want
to operate in the table on page 56.
Turn on the TV that you want to
operate.
While holding down the STANDBY
button on the RC-451DV that you
want to program, press the ENTER
button, and then release both
buttons.
Within 30 seconds, enter the 2-digit
code number.
Press some operation buttons for
the component that you want to
operate to check if the system
operates properly.
If the system operates properly, the code is
correct. If the component does not operate
properly, return to step 3.
Notes
• With some brand’s components, some buttons may not work
correctly.
• If more than one code is given in the table, try the code one by
one until you reach the code for your component (i.e. if the first
code does not work, then try the next).
• The code can be retained by changing the batteries within 1
minute. If the code is lost, store the pre-programming code again.
1
2
3
4
5
6
Controlling a TV
Set the DVD/TV switch to TV.
Press the ON button to turn on the
device.
Press the desired operation button.
CH+ : Changes the TV channel
upward.
CH– : Changes the TV channel
downward.
TV VOL+ : Increases the TV volume.
TV VOL– : Decrease the TV volume.
TV/VCR : Switches the TV/VCR inputs.
TV DVD
ENTER
STANDBY
2 3
4 5 6
7 8 9
1
0 +10
1
TV DVD
2 ON
3
COND. M
TV
ON / STANDBY
CH + CH -
FUNCTION M
SEARCH
2 3
4 5 6
7 8 9
1
0 +10
+
-
TV/ VCR
VOL +
VOL -
TV
LAST M DIMMER DISPLAY
ANGLE AUDIO SUBTITLE
MENU TOP MENU
SETUP RETURN
STOP PAUSE PLAY
DOWN UP FR FF
CLEAR
PROGRAM
DVD
RANDOM REPEAT A-B
STEP/ SLOW
REMOTE CONTROLLER RC - 451DV
ENTER
STANDBY
ON OPEN /CLOSE
ENTER
ON
STANDBY
TV/VCR
VOL +/–
CH +/–
DVD/TV
Number buttons