Integra DPS-7.2 - Manual (Page 51)

51
SN 29343135 DPS-7.2E
DISPLAY ENTER
Memory
Move Select
Off 1 2 3
Check
■ Adjusting the picture quality settings
– To create your own setting (2)
1 Use the cursor button ( 3) to select [Start] then press
ENTER.
DNR
Fine Focus
Sharpness
White Level
Black Level
Hue
Chroma Level
Gamma
Memory
On Off
min max
soft fine
min max
off max
green red
min max
– +
Off 1 2 3
Video Memory Select
Video Setup
5 Use the cursor buttons ( 2/3) to adjust the settings.
Adjust these while a disc is playing to see the effect of changes
immediately.
6 Repeat steps 4 and 5 to make adjustments to other
settings.
If you would like to save the settings in the player’s memory, be
sure to select either [1], [2], or [3] in the [Memory] setting to
establish which memory location to save the new settings in.
Please note that if you select a location where settings have
already been saved, the old settings will be replaced by the new
ones.
2 Use the cursor button ( ∞) to select [Video Setup] and press
ENTER.
3 Press DISPLAY.
4 Use the cursor buttons ( 5/∞) to select the setting and use
the cursor buttons ( 2/3) to adjust the settings.
Adjust these while a disc is playing to see the effect of changes
immediately.
5 To memorize the setting, select Memory 1, 2, 3, then press
ENTER.
The previous setting will be erased.
7 When you are finished making adjustments, press ENTER
to establish the new settings.