Integra DPS-7.2 - Manual (Page 64)

64
SN 29343135 DPS-7.2E
Causes
• The Setup screen Audio menu [Linear PCM
Out] setting is set to [Down Sample Off].
• The Setup screen Audio menu [Digital
Out] is set to [Off].
• A wrong sound signal conversion method
is selected.
• The pause mode is engaged.
• The volume level of TV or amplifier is set
to minimum.
• The DVD or CD is recorded in DTS audio.
• The multi aspect setting is not
appropriate.
• The TV is connected with an S-video
cord.
• The track name does not end in “.mp3” or
“.MP3”.
• More than 251 folders and tracks are
recorded on a disc.
• A multi-session disc is inserted.
• No batteries are inserted in the remote
controller.
• The batteries are worn out.
• The remote controller is not pointed at the
remote sensor of the DVD Player.
• The remote controller is too far from the
DVD Player.
Remedies
• Either connect using the analog outputs,
or set [Linear PCM Out] in the Audio
menu to [Down Sample On].
• Set [Digital Out] to [On].
• Check the current sound signal
conversion method, and select the right
setting.
• Press £ or 8 to exit the pause mode.
• Increase the volume level.
• DTS audio is only output from the digital
output jacks. Connect the digital output on
the player to the digital input on a receiver
or amplifier with a built in DTS decoder to
hear DTS audio.
• Change the aspect setting in the [TV
Screen] setting in the Setup screen Video
1 menu to the screen type most
appropriate to the TV or monitor you are
using.
• If you connected your TV with an S-Video
cord, in rare cases the TV picture may
appear stretched. In this case switch the
output from [S2] to [S1]
• This system will not recognize file that
does not end in ".mp3" or ".MP3" as an
MP3 track. Change the track name.
• This player only recognizes the first 250
folders and tracks on a disc. If there are
more folders/tracks than this, you will not
be able to play them.
• This player is not compatible with multi-
session discs. If the disc is multi-session,
you will only be able to play tracks
recorded onto the first session.
• Insert new batteries.
• Replace with new batteries.
• Point the remote controller at the remote
sensor of the DVD Player.
• Operate the remote controller within 5 m.
Symptoms
No sound is reproduced.
The screen is stretched or
aspect does not change.
Some MP3 tracks appear
to be missing from a disc.
The buttons on the DVD
Player operates but the
buttons on the remote
controller do not operate.
Pages
45
45
44, 45
25
–
16
48
49
5
5
5
9
9
9
9
D
VD Pla
y
e
r
Remote Contr
oller
Because the unit contains a microcomputer to provide advanced functions, it may malfunction due to external noise or static
electricity. If this happens, press the Power switch on the unit and then press it again after about five seconds.
Troubleshooting