Integra DPS-7.2 - Manual (Page 45)

45
SN 29343135 DPS-7.2E
■ DTS Out
This player is capable of outputting DTS digital audio for DVDs
recorded in DTS. When this player is connected to an AV
component that has a built-in DTS decoder, select [DTS]. If
your system is not equipped to decode DTS, select [DTS
3
PCM]. Refer to the operating instructions supplied with your
audio components if you are unsure about compatibility with
DTS.
—
—
—
—
V2 Video1 General A2 Language
Exit Move
Audio DRC
Dolby Digital Out
DTS Out
Linear PCM Out
MPEG Out
Audio1
Off
Dolby Digital
DTS
DTS
3 PCM
MPEG 3 PCM
Change DTS output mode
SETUP
—
—
—
—
SETUP
V2 Video1 General A2 Language
Exit Move
Audio DRC
Dolby Digital Out
DTS Out
Linear PCM Out
MPEG Out
Audio1
Off
Dolby Digital
DTS
3 PCM
Down Sample On
Down Sample Off
Change PCM output mode
■ MPEG Out
This player is capable of outputting the MPEG digital
bitstream. When the player is connected to an AV component
that has a built-in MPEG decoder, select the [MPEG] setting.
Otherwise, select [MPEG
3 PCM] to convert the digital signal
to the PCM signal, the digital signal output from a CD.
—
—
—
—
V2 Video1 General A2 Language
Exit Move
Audio DRC
Dolby Digital Out
DTS Out
Linear PCM Out
MPEG Out
Audio1
Off
Dolby Digital
DTS
3 PCM
MPEG
MPEG
3 PCM
Change MPEG audio output mode
SETUP
—
—
—
—
—
V2 Video1 General A2 Language
Exit Move
Audio DRC
Dolby Digital Out
DTS Out
Linear PCM Out
MPEG Out
Digital Out
Audio1
Off
Dolby Digital
DTS
3 PCM
Down Sample On
MPEG
3 PCM
On
Off
SETUP
Settings: DTS
DTS 3 PCM (Factory setting)
Note
If you have made digital audio connections to component(s) not
equipped to decode the DTS digital bitstream, be sure to select [DTS
3 PCM]. If a DTS signal is output without decoding, the output is
digital noise that could potentially cause damage to your speakers.
Settings: Down Sample On (Factory setting )
Down Sample Off
Note
On DVDs that contain copy protection, the 96 kHz signal may only
be output from the analog audio jacks.
Settings: MPEG
MPEG 3 PCM (Factory setting)
■ Digital Out
Expert
Depending on your preferences and the type of connections
made, you may opt not to have the digital audio signal output
at all. When this setting is set to [Off] there is no signal output
from the digital audio output jacks.
Make changes to the [Digital Out] setting in the Setup screen
Audio menu in the [Expert] menu mode (page 43).
Settings: On (Digital bitstream is output) (Factory setting)
Off (Digital bitstream is not output)
■ Linear PCM Out
If your AV amplifier (or other connected component) is
compatible with high sampling rates (96 kHz), set this to
[Down Sample Off], otherwise set it to [Down Sample On] (96
kHz audio is converted to a more compatible 48 kHz). Check
the manual that came with the other component if you’re
unsure whether it is 96 kHz compatible.