IBM eserver xSeries 330 - Manual (Page 33)

Chapter 2. Installing Options 21
Testing the C2T chain
After connecting the C2T chain, you will need to test the monitor, keyboard, and
pointing device to be sure that they work with each of the servers.
Follow these steps to test the C2T cabling:
1. With the servers powered up and the monitor on, press the select button on server
1 in the C2T chain.
2. Check the monitor to see if it is working.
3. Use the mouse or pointing device to open an application.
4. Test your keyboard by typing a few words within an application.
5. Repeat steps 1 through 4 for each of the servers in the chain.
Note: If you cannot use the devices, check your cable connections and retry the test.
If the problem persists, turn off the servers and connect the C2T device break
out cable directly to the Console (Out) port of the server. Power up the server
and retry the devices. If the devices work, then you probably have a bad C2T
chaining cable. Replace the cable and retry the devices in the C2T chain
configuration.
Cable management
Use the cable ties and hook-and-loop straps that are supplied with your server to
secure the cables.
Note: Do not secure cables too tightly. Over tightening can cause internal damage
to cables.