Intel SBC-455 - Manual (Page 49)

Chapter 3 AMI WinBIOS setup 41
Quick Boot:
Set this option to Enabled to instruct AMIBIOS to boot quickly
when the computer is powered on. This option replaces the old
Above 1 MB Memory Test Advanced Setup option.
Setting Description
Disabled AMIBIOS test all system memory. AMIBIOS waits up
to 40 seconds for a READY signal from the IDE hard
disk drive. AMIBIOS waits for .5 seconds after
sending a RESET signal to the IDE drive to allow the
IDE drive time to get ready again. AMIBIOS checks
for a <Del> key press and runs WINBIOS Setup if
the key has been pressed.
Enabled AMIBIOS does not test system memory above 1 MB.
AMIBIOS does not wait up to 40 seconds for a
READY signal from the IDE hard disk drive. If a
READY signal is not received immediately from the
IDE drive, AMIBIOS does not configure that drive.
AMIBIOS does not wait for .5 seconds after sending
a RESET signal to the IDE drive to allow the IDE drive
time to get ready again.
You cannot run WINBIOS Setup at system boot,
because there is no delay for the
Hit <Del> to run
Setup message.
Boot Up Sequence:
This option sets the sequence of boot drives (floppy drive A:, hard
disk drive C:, or CD-ROM drive) that the AMIBIOS attempts to
boot from after AMIBIOS POST completes. The settings are
C:,A:,CDROM, CDROM,A:,C:, or A:,C:,CDROM. The default
settings are A:,C:,CDROM.
Boot Up Num Lock:
Set this option to Off to turn the Num Lock key off when the
computer is booted so you can use the arrow keys on both the
numeric keypad and the keyboard. The settings are On or Off. The
default settings are on.