Intel SBC-455 - Manual (Page 77)

Chapter 5 Flat Panel/ CRT Controller 69
9. Follow the directions on the screen to complete the setup. In
most cases, you may press <ENTER> to accept the suggested
option. When Setup is done, it will return to DOS. Type
WIN
<ENTER> to start Windows with the new display driver.
Changing Display Drivers from DOS
To change display drivers from DOS, change to the Windows directory
and run Setup, repeating steps 4 and 5 from the previous page.
Besides the special display drivers marked by an asterisk (*), you
should be able to use the following standard drivers:
VGA 640 x 480, 16 colors
Super VGA 800 x 600, 16 colors
Panning Drivers
Special panning drivers are provided to allow high-resolution modes to
be displayed on a flat panel or CRT. These drivers will show a section
of a larger screen, and will automatically pan or scroll the screen
horizontally and vertically when the mouse reaches the edge of the
display.
OS/2
These drivers are designed to function with the OS/2 Version 3 and 2.1
operating systems.
Driver installation
NOTE: Always use the INSTxx.CMD for the FIRST
installation of the video device drivers. To change
video resolutions, follow Step 3 below.
To install the drivers, follow these instructions:
1. The system display must be set to VGA mode before installing
the OS/2 SVGA drivers. Open an OS/2 full screen or windowed
session.