Intel SBC-455 - Manual (Page 78)

70 PCM-5890 User's Manual
2. Place the OS/2 Display Driver Diskette in drive A. Type
A: <ENTER> to make this the default drive. Then type INST2X
A: C: <ENTER> (for OS/2 2.1x systems) or INST30 A: C:
<ENTER> (for OS/2 Version 3 systems). Once the Install
Program is completed, do a system shutdown and reboot.
3. After the system has rebooted, follow these instructions:
A) OS/2 2.1x
Open an OS/2 full-screen or windowed session. At the OS/2
prompt, type
DSPINSTL <ENTER> to install the new device
driver and configure the video system.
B) OS/2 Version 3
Go to the System Setup folder and run Selective Install to install the
new device driver and configure the video system.
Follow the instructions of the program to set up the OS/2 drivers in
your system. First, select Primary Display. From the list of Primary
Display Adapter Types, select Chips and Technologies 655XX.
From the list of available Display Resolutions, select a display
resolution. The correct source directory must be specified. Once
the installation is complete, the system must be shut down and
restarted for changes to take effect.
WIN-OS/2
Please note the following limitations regarding WIN-OS/2.
1. The WIN-OS/2 full screen session should be set to Enhanced
Capability. The default setting is Standard Mode. If this setting is
not changed, Windows will not run.
2. WIN-OS/2 should be started by selecting the WIN-OS/2 Full
Screen Icon in the Command Prompts folder, or with the WIN
command in a DOS Full Screen or OS/2 Full Screen session.
3. Do not start WIN-OS/2 in a DOS or OS/2 Window. The system
does not support the enhanced video mode being used in a
window, and therefore will not run.