Inter-Tel INT1100 - Manual (Page 11)

[ 11 ]
GETTING ST
AR
TED
G E T T I N G S T A R T E D
• Use only the supplied AD-312 AC adapter.
Do not use any other AC adapter.
• Connect the AC adapter to a continuous power supply.
• Place the base unit close to the AC outlet so that you can unplug
the AC adapter easily.
C. Connect the base unit
1) Connect the AC adapter to the DC IN 9V
jack and to a standard 120V AC wall
outlet.
2) Set the base and charger (for TRU5860-2
only) on a desk or tabletop, and place the
handset in the base unit as shown.
3) Make sure the status LED illuminates. If the LED does not
illuminate, check to see that the AC adapter is plugged in
and that the handset makes good contact with the base
charging contacts.
Place the power cord so
that it does not create
a trip hazard or where it
could become chafed
and create a fire or
electrical hazard.
4) After installing the battery pack in the handset,
charge your handset at least 15-20 hours before
plugging into the phone line.
5) Once the handset battery pack is fully charged,
connect the telephone line cord to the TEL LINE
jack and to a telephone outlet.
If your telephone outlet isn't modular
type, contact your telephone company
for assistance.
Modular
INT1100 Manual-5.0.qxd 1/29/04 12:09 AM Page 11 Bob's Garage: New Backup: Clients:CoastlineCreative:Clients:Int