Inter-Tel INT1100 - Manual (Page 24)

[ 24 ]
2) Press select/ch, “ Store/Edit Name ” appears.
3) Store the name (up to 16 characters) by using the number keypad.
• See the “Steps for entering names and special characters” (see page 27).
• Use call id/
and /RocketDial/ to move the cursor to the desired location.
• Use xfer/del to delete characters as needed.
• Press and hold xfer/del to delete all the characters.
If a name is not required, go to step 4.
4) Press select/ch to store the name,
“ Store/Edit No. ” appears.
5) Press the number keypad to enter the phone number (up to 20 digits),
press select/ch to store the number.
6) “ Distinctive Ring ” appears. Press + or - to move the pointer
to one of the Distinctive Ring options, then press select/ch.
7) “ Speed Dial ” appears. Press + or - to move the pointer to select
the Speed dial location (10 locations: SPD1-SPD0).
8) Press select/ch. You will hear a confirmation tone and
“ Done! ” appears on the display.
P H O N E B O O K
If you choose not to store a “ Distinctive Ring ”, simply select the “ No
Selectn ” option.
If you choose not to store the name/number as a Speed Dial, simply
select the “
No Selectn ” option.
• If you select a Speed
dial location where a
number is already
stored, the new number
will replace the old
number, and the old
number will be stored as
a phonebook location.
• When the memory is
full, you will hear a
beep and “
Memory
Full ” appears. You
cannot store names
and numbers.
• The pause key counts
as one digit. Pressing
redial/p more than
once increases the
length of pause
between numbers.
INT1100 Manual-5.0.qxd 1/29/04 12:09 AM Page 24 Bob's Garage: New Backup: Clients:CoastlineCreative:Clients:Int