Intel ECB-870 - Manual (Page 65)

ECB-870
ECB-870 User’s Manual 53
4.5.3.11 Typematic Delay (Msec)
Sets the delay time after the key is held down before it begins to repeat the keystroke.
The choice: 250, 500, 750, and 1000.
4.5.3.12 Security Option
Select whether the password is required every time the system boots or only when you
enter setup.
System
The system will not boot and access to Setup will be denied if the
correct password is not entered at the prompt.
Setup
The system will boot, but access to Setup will be denied if the correct
password is not entered at the prompt.
Note: To disable security, select PASSWORD SETTING at Main Menu and then you will
be asked to enter password. Do not type anything and just press <Enter>, it will
disable security. Once the security is disabled, the system will boot and you can
enter Setup freely.
4.5.3.13 APIC Mode
The BIOS supports versions 1.4 of the Intel multiprocessor specification. When enabled,
The MPS Version 1.4 Control for OS can be activated.
The choice: Enabled/Disabled.
4.5.3.14 OS Select for DRAM > 64
Select the operating system that is running with greater than 64MB of RAM on the system.
The choice: Non-OS2, OS2.
4.5.3.15 Report No FDD for Win 95
While the FDD in “ STANDARD CMOS SETUP ” is set to NONE, set this option to No to
release IRQ6 for passing Win95 logo. This option is irrelevant under normal operation.
The choice: Yes, No.
4.5.3.16 Small Logo (EPA) Show
When you select “ Enabled” the screen shows as “Energy Star” picture at the front side up
right. “Disabled” is close this picture.
The choice: Enable, Disable.