Intel ECB-870 - Manual (Page 75)

ECB-870
ECB-870 User’s Manual 63
4.5.6.10 HDD Power Down
This instructs hard drives to shut off while in the Power Management modes.
4.5.6.11 Soft-Off by PWR-BTTN
When set to “Delay 4 Sec.”, the power button has a dual function where pressing less than
4 seconds will place the system in sleep mode and shut down the system when the button
is held more than 4 seconds. “Instant-Off”, the system will be shut down right away when
the power button is pressed.
The choice: Instant-Off, Delay 4 Sec.
4.5.6.12 CPU Thermal-Throttling
Set the percent of power consumption when CPU over heat.
The choice: 87.5﹪, 75.0﹪, 62.5﹪, 50.0﹪, 37.5﹪, 25.0﹪, 12.5﹪.
4.5.6.13 Wake-Up by PCI card
If your PCI card supports PME (Power Management Event) signal and this item is set as
Enabled, PCI peripherals drive PME signal to wake the system from low-power states S1-
S5.
The choice: Disable, Enable.
4.5.6.14 Power On by Ring
The option lets you specify enable or disable external Modem Wake Up function. It
powers up the computer when the modem receives a call while the computer is in Soft-off
mode.
The choice: Disable, Enable.
Note:
The computer cannot receive or transmit data until the computer and application
are fully running. After the item is set as enabled, the system must enter to OS
once before system is turned off.
4.5.6.15 Wake up on LAN
This allows you to remotely power up your systems through your network by sending a
wake-up frame or signal. With this feature, you can remotely upload/download data
to/from systems during off-peak hours. Set to Enabled to set this feature. Please refer to
session 2.4.6 for more information.
The choice: Disable, Enable.