IBM Nortel 10 - Manual (Page 22)

12. Attach any cables that are required by the GbE switch module, see
Chapter 4, “Cabling,” on page 21. For the locations of the connectors on
the BladeCenter unit, see the documents that came with the BladeCenter
unit.
13. Replace the acoustic-attenuation module, if you removed it in Step 2.
Removing the GbE switch module
To remove the GbE switch module, complete the following steps:
1. Read the safety information beginning on page v and “Installation
guidelines” on page 9.
2. Remove the acoustic-attenuation module, if one is installed, from the rear
of the BladeCenter unit. For more information, see the documents that
came with the BladeCenter unit.
3. Disconnect any cables from the GbE switch module that you are removing.
4. Pull the release latch toward the bottom of the GbE switch module as
shown in the following illustration. The module moves out of the bay
approximately 0.64 cm (0.25 inch).
I/O module
Release latch
RS232
TX/RX
LINK 1
TX/RX
LINK 2
TX/RX
LINK 3
TX/RX
LINK 4
3
5. Slide the GbE switch module out of the bay and set it aside.
6. Place either another GbE switch module or a filler module in the bay
within 1 minute.
7. If you placed another GbE switch module in the bay, reconnect any cables
that you disconnected. For more information about cabling the 10GbE
switch module, see Chapter 4, “Cabling,” on page 21.
12 Nortel 10 Gigabit Uplink Ethernet Switch Module: Installation Guide