IBM Nortel 10 - Manual (Page 33)

1. Remove the protective caps from the end of the fiber-optic cable.
Protective cap
Fiber-optic
cable
2. Gently slide the fiber-optic cable into the XFP module until it clicks into
place.
RS232
TX/RX
LINK 1
TX/RX
LINK 2
TX/RX
LINK 3
TX/RX
LINK 4
3
3. Check the LEDs on the GbE switch module. When the GbE switch module
is operating correctly, the green link LED is lit. For information about the
status of the switch module LEDs, see “LEDs” on page 6.
Chapter 4. Cabling 23