IBM Nortel 10 - Manual (Page 40)

2. On the management station, open a console window and make sure that
the serial port is configured with the following settings:
v 9600 baud
v 8 data bits
v No parity
v 1 stop bit
v No flow control
3. Type the user name and password. The default user name is admin . The
default password is admin .
The serial port is compatible with the standard 16550 Universal Asynchronous
Receiver/Transmitter (UART) protocol. The RS-232 serial port is enabled by
default.
Configuring the GbE switch module using the switch-module
Browser Based Interface
This section describes how to use the GbE switch module Browser Based
Interface (BBI) to access and configure the internal switching software. For
more information on the BBI, see the Nortel 10 Gb Uplink Ethernet Switch
Module for IBM BladeCenter Browser Based Interface Quick Guide.
This section also describes some of the Web interface switch-module
management features.
The GbE switch module offers an embedded HTML, browser-based interface
that you can use to manage the switch through Netscape Navigator and
Communicator, or Microsoft ® Internet Explorer. This interface is enabled by
default. The browser-based interface acts as an access tool and can
30 Nortel 10 Gigabit Uplink Ethernet Switch Module: Installation Guide