IBM Nortel 10 - Manual (Page 29)

Note: The illustrations in this document might differ from your device.
SFP module
Wire tab
4. Insert the SFP module into the SFP module port until it clicks into place.
Note: The illustrations in this document might differ from your device.
RS232
TX/RX
LINK 1
TX/RX
LINK 2
TX/RX
LINK 3
TX/RX
LINK 4
3
SFP module
Attention: To avoid damage to the cable or the SFP module, make sure
that you do not connect the fiber-optic cable before you install the SFP
module.
5. Connect the RJ-45 cable and any cables you disconnected earlier. For more
information about connecting the cable, see “Connecting the SFP module
cable” on page 24.
Removing an SFP module
To remove an SFP module from the GbE switch module, complete the
following steps:
1. Read the safety information beginning on page v and “Installation
guidelines” on page 9.
Chapter 3. Installing and removing options 19