Janome MB-4 - Manual (Page 13)

10
Setting the Thread Cones or Spools of Thread
Use the 4 spool pins in the front row for sewing, and
second row spool pins are for the standby spools.
Use the rear most spool pin for bobbin winding.
Felt rings of two sizes are provided to accommodate
various types of spools of thread and thread cones.
Use the large felt rings for large thread cones. For small
thread cones or spools of thread, insert the small felt
rings into the large rings.
q Spool pin
w Felt ring (large)
e Felt ring (small)
r Small spool of thread
t Spool pin for bobbin winding
Setting the thread cone
Attach the spool rests on the spool pins.
Place the thread cones on the spool pins.
Cover the thread cone with the spool net if the thread is
shaky or kinky when sewing.
If the net is too long for a spool, fold the net and place it
on the spool.
y Spool rest
u Spool net
Setting the spool of thread
Place the spool of thread on the spool pin, with the
thread coming out from the left backside.
Attach the spool cap and firmly press it against the spool.
i Spool cap
NOTE:
To prevent the thread from unraveling, leave the net on
the thread cone or hook the thread end into the notch
of the spool when it is not in use.
o Notch
q
w
e
r
t
w
y
u
i
o