Janome MB-4 - Manual (Page 24)

21
Threading the needle with the needle threader
z Hold the needle threader with a triangle mark facing
up. Insert the thread into the Y-notch of the threader
from the right.
q Triangle mark
w Y-notch
x Slide the threader down along the needle while
pushing it gently until the threader pin goes into
the needle eye.
Place the V-notch over the needle just above the
needle eye.
e V-notch
c Push the threader until the threader pin comes out
through the needle eye with a loop of thread.
r Threader pin
v Remove the threader from the needle slowly,
leaving the thread loop behind the needle eye.
Using the tweezers, pull the loop of the thread out
to the back.
t Tweezers
q
w
e
r
z
x
c
v
t