Janome MB-4 - Manual (Page 71)

68
Trim Tail Length
Thread Break Stitch Count
Number of Jumps
Jump Thread Trimming
7
M
8
3
Trim Tail Length
Thread Break Stitch Count
Number of Jumps
Jump Thread Trimming
7
M
8
3
Trim Tail Length
Thread Break Stitch Count
Number of Jumps
Jump Thread Trimming
7
M
8
3
Trim Tail Length
Thread Break Stitch Count
Number of Jumps
Jump Thread Trimming
7
M
8
3
⁄9 Setting the trim tail length
Some times you need to adjust the tail length of the
thread being trimmed depending on the thickness
and type of the thread.
Press the circle key next to “+” or “–“ to adjust the
trim length.
q Circle key (+, –)
You can select one of the following options.
S: Short
M: Medium
L: Long
¤0 Setting the thread detector sensitivity
You can adjust the sensitivity of the thread detector
by setting stitch count to judge thread breakage.
Press the circle key next to “+” or “–“ to adjust the
sensitivity.
q Circle key (+, –)
The adjustable range is from 0 to 16.
¤1 Jump thread trimming ON/OFF
If you wish to trim jump threads automatically, press
the circle key next to “ON”.
A check mark will appear in the box.
Press the circle key next to “OFF” to disable the jump
thread trimming.
w Circle key (ON, OFF)
¤2 Setting the number of jumps for trimming
You can adjust number of jumps, which triggers the
jump thread trimming.
The machine will trim the jump thread automatically
after the specified number of jump stitches.
Press the circle key next to “+” or “–“ to adjust the
number of jumps.
q Circle key (+, –)
Press the OK key to register the new settings.
Or press the next page key to go to the next page.
q
⁄9
q
¤0
w
¤1
q
¤2