Janome MB-4 - Manual (Page 59)

56
4/8 88x90mm
21 min
1 / 5 Color
1 / 8544 ST
1 Ivory White 253
2 Bamboo 224
3 Tangerine 274
1
2
3
4 Orange 203
1 Sienna 256
4
5
Machine starts to Run.
M2:126 X 110mm
v Press the START/STOP button, the LCD
screen will show the reminder asking you to
confirm the hoop type to be used.
e START/STOP button
r Reminder message
NOTE:
If you press the START/STOP button when the
tension release lever is in the open position, a
warning message will appear.
Pull the tension release lever up to close the
tension disk.
Check the hoop size and press the START/
STOP button again to sew a few stitches.
b Press the START/STOP button to stop the
machine.
Trim the thread at the beginning.
Then, press the START/STOP button again.
The machine will sew up to the fourth color
and stop automatically.
Re-thread each needle with the next color
and press the START/STOP button to
continue sewing.
Refer to page 28 for how to remove the hoop.
If the thread breaks or runs out while stitching,
the machine will automatically stop and the
hoop will go back to the position where the
thread broke or ran out.
However, you can fine-tune the restarting
position by moving the hoop.
Press the stitch forard button to move the hoop
forward 10 stitches.
t Stitch forward button
Press the stitch back button to move the hoop
backward 10 stitches.
y Stitch back button
y
e
r
t
4/8 88x90mm
21 min
1 / 5 Color
1 / 8544 ST
1 Ivory White 253
2 Bamboo 224
3 Tangerine 274
1
2
3
4 Orange 203
1 Sienna 256
4
5
v
b