JVC VN-V686UAPI - Manual (Page 89)

Interpretation Acquire the IP address setting of the restricted client. Setting is possible up to 10 items. Specify a
value between 1 to 10 for the number. The following will be returned if subnet mask was specified.
Example of Response 2
network.access_control(stream_out).host(1)=10.0.0.0/24&200 OK
The above example indicates that the range is between 10.0.0.0 to 10.0.0.255. There are also cases when FQDN
instead of IP address is set.
Example of Response 3
network.access_control(stream_out).host(1)=somedivision.somecompany.com&200 OK
Allowed users admin, operator
Setting IP Address of Restricted Client for VN-V686
Format /api/param?network.access_control(stream_out).host(Number)=data
Example When setting the first IP address
/api/param?network.access_control(stream_out).host(1)=10.0.0.100
Example of Response network.access_control(stream_out).host(1)&200 OK
Interpretation Change the IP address setting of client restriction. Setting is possible up to 10 items. Specify a value
between 1 to 10 for the number. A range of IP address may be specified if the subnet mask is also specified. For
example, set as follows to specify a range between 10.0.0.0 to 10.0.0.255.
Example /api/param?network.access_control(stream_out).host(1)=10.0.0.0/24
It is also possible to set using FQDN instead of IP address. Set as follows if the setting is to be left blank.
Example /api/param?network.access_control(stream_out).host(1)=%00
Allowed user admin
6.15. Time
The APIs below are related to time. These are equivalent to the features on the Time page of the WEB setting page.
Refer to the instruction manual for details on the Time page.
Getting On/Off of SNTP Client from VN-V686
Format /api/param?network.ntp.status
Example of Response network.ntp.status=off&200 OK
Interpretation Acquire the on/off status of SNTP client. Either on or off will be returned.
Allowed users admin, operator, user
Setting On/Off of SNTP Client, or Validate Changes for VN-V686
Format /api/param?network.ntp.status=data
89