Janome Memory Craft 6500 - Manual (Page 15)

13
Winding the bobbin
1 Pass the thread through the guide on the thread
guide post from behind.
1 Thread Guide Post
2 Pass the thread under the bobbin winding
tension disk.
2 Bobbin Winding Tension Disk
3 Thread through the hole in the bobbin from the
inside to the outside.
3 Bobbin Winder Spindle
4 Put the bobbin on the bobbin winder spindle.
Push the bobbin winder stopper to the left.
4 Bobbin Winder Stopper
5 6 Hold the free end of the thread in your hand and
press the bobbin winding button.
Press the bobbin winding button again to stop
the bobbin when it has made several turns, and
cut the thread close to the hole in the bobbin.
5 Bobbin Winding Button
7 Press the bobbin winding button again. When
the bobbin is fully wound, the machine will stop
automatically.
Return the bobbin winder stopper to its original
position, and cut the thread.
NOTE:
The Memory Craft 6500 has an exclusive motor for
bobbin winding, which allows you to wind the bobbin
while stitching.
4
3
5
1
1
2
7
5
4
3
2
6