Janome Memory Craft 6500 - Manual (Page 19)

17
Automatic Needle Threader
1 Raise the needle to its highest position by
pressing the up/down needle button twice.
2 Turn the power switch off.
3 Lower the presser foot.
1 Up/Down Needle Button
4 Depress the needle threader knob as far as it will
go. The hook comes out through the needle eye
from behind.
2 Needle Threader Knob
3 Hook
5 Draw the thread down around the threader guide
and under the hook.
4 Threader Guide
6 Release the threader knob slowly while holding
the thread end with your hand. A loop of the
thread is pulled up through the needle eye.
5 Loop of Thread
7 Remove the loop from the threader and pull out
the thread end from the needle eye.
NOTES:
The automatic threader works well with the threads
#50-100 and needles #11-16, including the blue tipped
needle.
The automatic needle threader cannot be used for
threading the twin needle.
If the hook fails to pull a loop of the thread, check the
needle and its setting.
1
4
5
6
1
7
2 3
2
3
4
3
5