Janome Memory Craft 6500 - Manual (Page 46)

44
3 Pull the buttonhole lever down as far as it will go.
1 Buttonhole Lever
NOTE:
If you start sewing without pulling down the buttonhole
lever, the LCD screen will show a warning and the machine
will stop after a few stitches. Pull the buttonhole lever down
and restart the machine.
Auto thread cutter
If you press the auto thread cutter button after
selecting a buttonhole, the LED signal will turn on.
The machine will stop automatically and trim the threads
when the buttonhole is completed.
4 Insert the corner of the fabric under the foot. Press
the up/down needle button twice.
Remove the fabric to the left to draw the needle
thread through the hole of the foot.
Place the garment under the foot, and lower the
needle at the starting point of the buttonhole mark.
Then lower the automatic buttonhole foot R.
2 Buttonhole Mark
3 Needle Thread
4 Bobbin Thread
5 Starting Point
NOTE:
Make sure there is no gap between the slider and spring
holder, otherwise the left and right length will be different.
6 Slider
7 Spring Holder
8 Sewing Gap
1
2
3
7
5
4
6
8
3
4
LED Signal