Janome Memory Craft 6500 - Manual (Page 31)

29
Basting
Machine Setting
Pattern:
07
Thread tension:1-3
Presser foot:
Darning foot P-2
Foot pressure: 1
Feed dog:
Dropped
The basting stitch is used to hold fabric layers together
during fitting.
Lower the feed dog
Set the foot pressure dial at “1”.
Attaching the darning foot P-2
Loosen the thumbscrew and remove the foot holder.
Attach the darning foot P-2 to the presser bar putting the
pin on the needle clamp screw.
Tighten the thumbscrew firmly with the screwdriver.
1 Thumbscrew
2 Pin
3 Needle Clamp Screw
To sew:
Draw the both needle and bobbin thread to the back.
Depress the foot control. The machine will take one stitch
and stop automatically.
Release the foot control.
Hold the fabric taut and slide it to a place where you want
the next stitch.
CAUTION:
Do not pull the fabric while stitching. It may deflect the
needle causing it to break.
1
3
2