Janome Memory Craft 6500 - Manual (Page 7)

5
GETTING READY TO SEW
Connecting the Power Supply
Turn off the power switch.
Insert the foot control plug into the machine socket.
Insert the machine plug into the machine socket.
Insert the power supply plug into the wall outlet.
Turn on the power switch.
1 Power Switch
2 Foot Control Plug
3 Machine Socket
4 Machine Plug
5 Power Supply Plug
6 Wall Outlet
NOTE:
If you turn off the power switch, wait for 5 seconds before
turning it on again.
For Your Safety:
While in operation, always keep your eyes on the sewing
area, and do not touch any moving parts such as the thread
take-up lever, handwheel or needle.
Always turn off the power switch and unplug from the power
supply:
- when leaving the machine unattended.
- when attaching or removing parts.
- when cleaning the machine.
Do not place anything on the foot control, otherwise the
machine will run intermittently.
1
4
3
2
3
6
5
Controlling Sewing Speed
Speed control lever
You can limit the maximum sewing speed by the speed control lever according to
your sewing needs.
To increase sewing speed, slide the lever to the right.
To decrease sewing speed, slide the lever to the left.
Foot control
Pressing on the foot control can vary sewing speed. The harder you press the foot
control, the faster the machine runs.
NOTES:
The machine runs at the maximum speed set by the speed control lever when the
foot control is being fully depressed.
Keep the foot control free from accumulation of lint, dust and loose cloth.
Do not place anything on the foot control.
Operating Instructions:
Foot controller Model 21371 is for use with sewing machine model
MC6500.
Operating Instructions:
The symbol "O" of a switch indicates the "off" position of a switch.
For appliances with a polarized plug (one blade wider than the other). To reduce the risk of electric shock, this plug is
intended to fit in a polarized outlet only one way. If it does not fit fully in the outlet, reverse the plug. If it still does not
fit, contact a qualified electrician to install the proper outlet. Do not modify the plug in any way.