JBL SYNTHESIS SDP-40HD - Manual (Page 85)

SDP-40HD Setup
3-45
MANUAL CALIBRATION (continued)
SETTING BASS PEAK LIMITERS
The BASS PEAK LIMITERS option displays the BASS PEAK LIMITERS menu to set amplitude limits on low frequency signals sent to the Main Zone
audio output Subwoofer L/R and LFE connectors. This menu also sets amplitude limits on low frequency signals redirected to other Main Zone
audio output connectors. The SDP-40HD is equipped with an internal limiter to prevent low frequency signals from exceeding a designated
output level. This is essential for Dolby Digital and DTS(-ES) sources that produce low frequency signal peaks at much higher output levels than
2-channel sources. In home theaters, there is a danger of the subwoofers and their associated amplifiers overloading when attempting to
reproduce low frequency signals.
Note:
You should configure BASS PEAK LIMITERS menu parameter settings
whether output levels are automatically or manually calibrated.
SPEAKERS SETUP MANUAL LEVELS CALIBRATION BASS PEAK LIMITERS
SPEAKER SETUP
SET CROSSOVERS
CHECK MICROPHONES
AUTOMATIC
MANUAL
MAIN MENU
MODE ADJUST
AUDIO CONTROLS
SETUP
SETUP
INPUTS
SPEAKERS
REAR PANEL CONFIG
DISPLAYS
VOLUME CONTROLS
TRIGGERS
LOCK OPTIONS
SET CROSSOVERS
BEFORE CALIBRATING
LEVELS CALIBRATION
INTERNAL NOISE TEST
DACS CALIBRATION
BASS PEAK LIMITERS
BASS PEAK LIMITERS
CAL NOISE
L/R LIMITER
L/R LIMIT ADJ
LFE LIMITER
LFE LIMIT ADJ
!CAUTION!
HIGH AUDIO LEVELS
ON
OFF
100dB
OFF
100dB
ON
OFF
75 to 120dB
CUSTOM SETUP
40 Hz
60 Hz
60 Hz
60 Hz
40 Hz
OFF
N/A
APART
SPEAKER SETUP
CUSTOM SETUP
SYNTHESIS 7 CH SETUP
C
R SR RR
L SL RL M
SUB
80Hz 80Hz 80Hz
80Hz
80Hz 80Hz 80Hz 80Hz
SPEAKER DISTANCES
LEVELS CALIBRATION
Parameter Default Setting Possible Setting
CAL NOISE ON ON, OFF
L/R LIMITER OFF ON, OFF
L/R LIMIT ADJ 100dB 75 to 120dB
LFE LIMITER OFF ON, OFF
LFE LIMIT ADJ 100dB 75 to 120dB