JBL SYNTHESIS SDP-40HD - Manual (Page 87)

SDP-40HD Setup
3-47
MANUAL CALIBRATION (continued)
LFE LIMITER ADJ 75 to 120dB
Specifies the output level restriction the SDP-40HD applies to the
LFE output connector.
To set the LFE LIMIT ADJ parameter:
1. Select the LFE LIMIT ADJ parameter.
The parameter initially sets to 75dB.
2. Press the or arrow button to change the parameter
value.
The selected output level restriction is applied when the LFE
LIMITER parameter is set to ON.
REAR-PANEL CONFIGURATION
Selecting the REAR PANEL CONFIG option displays the REAR PANEL
CONFIG menu shown below, to configure the analog audio input
connectors as eight (Left/Right) stereo connectors or as five
(Left/Right) stereo connectors and one 5.1-channel configuration
(Front L/R, Center, Subwoofer, Side L/R).
8 STEREO INPUTS
Select the 8 STEREO INPUTS option to configure the analog audio
input connectors as eight stereo connectors.
When 8 STEREO INPUTS is selected:
• All analog audio input connectors are configured as stereo
connectors.
• The 5.1-channel connector is not available.
• Input sources that were assigned to the 5.1-channel connector
are reassigned to the stereo connector labeled 6.
SPEAKERS SETUP LEVELS CALIBRATION BASS PEAK LIMITERS LFE LIMITER ADJ
REAR PANEL CONFIG SETUP
SETUP
INPUTS
SPEAKERS
REAR PANEL CONFIG
DISPLAYS
VOLUME CONTROLS
TRIGGERS
LOCK OPTIONS
MAIN MENU
MODE ADJUST
AUDIO CONTROLS
SETUP
REAR PANEL CONFIG
8 STEREO INPUTS
OR
5 STEREO & 5.1 ANLG
5 STEREO & 5.1 ANLG
FOR REAR PANEL CFG
8 STEREO INPUTS
FOR REAR PANEL CFG
REAR PANEL CONFIG SETUP 8 STEREO INPUTS