JVC GC X 1 - Manual (Page 22)

22
EN
GETTING STARTED (cont.)
Inserting the Memory Card
Make sure to turn the Power dial to “OFF”, when
inserting a Memory card. Memory card is not
loaded in the camera, when purchasing the camera.
1 Open the Memory card cover.
•Slide the knob and then pull the cover.
2 Insert the Memory card.
•Insert the card so that the contact surface is
facing up and the notch on the card is on the
right.
•Do not touch the contact surface on the card.
3
Close the Memory card cover.
•Slide the knob to lock the cover.
NOTES:
● There are two types of Memory cards (the 3.3V
type which is indicated by a notch on the right
side, and the 5V type which is indicated by a
notch on the left side). This camera uses only
Memory cards (3.3V) with a notch on the right
side.
● The maximum memory card capacity that can be
used with this camera is 64MB.
● To avoid damage to the Memory card, do not
drop or strike the Memory card against hard
objects.
● To protect the entire content of the Memory card
after shooting, peel and stick a write protect
sticker as shown in the right.
Contact surface
Where the write protect
sticker is placed
Removing the Memory Card
1 Open the Memory card cover.
•Slide the knob and then pull the cover.
2 Remove the Memory card.
•Push on the card to remove it.
5V 3.3V