John Deere AC-G3200i - Manual (Page 24)

Preparing the Generator
24 Operator’s Manual
PRE-OPERATION
BATTERY INSTALLATION:
1. Attach terminals to a lead-acid battery already charged.
Mount the battery onto the position as specified below, with
its terminals facing inward.
2. Insert each long bolt through the specified hole, its tip pointing
outward.
3. Put the supporting arm on the long bolts and tighten with
the butterfly nuts. (Push the lead-acid battery all the way
inward.)
4. Arrange the wiring so that it won’t be damaged by possible
vibration caused by the engine.
5. Only after checking that the engine’s starter key in the “OFF”
position, securely connect the red cable, to the positive (+)
terminal. And then connect the other cable to the negative (-)
terminal.
Red Cable: to the (+) terminal
Black Cable: to the (-) terminal
RECOMMENDED BATTERY
LEAD-ACID BATTERY
AC-G3200i AC-G4300i
USA SW7L-BS SW12AL-A
CANADA SWC7L-BS SWC12AL-A
CAUTION: ENGINE DAMAGE WILL OCCUR IF THE TERMINAL CONNECTIONS
ARE CONNECTED IN THE INCORRECT MANNER.
RED CABLE
RED
CABLE
5
LESS THAN
131 mm [5.2 in.] (AC-G3200i)
162 mm [6.4 in.] (AC-G4300i)
LESS THAN
114 mm [4.5 in.] (AC-G3200i)
136 mm [5.4 in.] (AC-G4300i)
LESS THAN
71 mm [2.8 in.] (AC-G3200i)
82 mm [3.2 in.] (AC-G4300i)
1
2
3
4
5
1
6
2
3
4
Battery Base
Flange Bolt
Screw
Accessory parts
Battery Band
Bolt and Nut
6 Battery cover