Speaker layout – JVC SP-THS55F User Manual
Page 18
 
INSTALLING YOUR NEW UNIT
Page 15Monday, 28 March 2005 21:23
Filename [TH-R1R3EU_05Name.fm]
Masterpage:Left+
15
●
Place the satellite speakers on a flat and level surface.
●
The front and centre speakers are magnetically shielded to avoid 
colour distortions on TVs. However, if not installed properly, they 
may cause colour distortions. So, pay attention to the following 
when installing the speakers.
^ When placing the speakers near a TV set, turn off the TV’s 
main power switch or unplug it before installing the speakers. 
Then wait at least 30 minutes before turning on the TV’s main 
power switch again.
Some TV’s may still be affected even though you have followed 
the above. If this happens, move the speakers away from the TV.
●
The surround speakers are not magnetically shielded.
If it is located near the TV or monitor, it will probably cause colour 
distortion on the screen. To avoid this, do not place the speaker 
near the TV or monitor.
●
Be sure to place the powered subwoofer to the TV’s right. If you 
place the powered subwoofer to the TV’s left, keep sufficient 
distance between them to prevent the TV screen from appearing 
mottled.
●
When installing the satellite speakers on the wall;
^ Be sure to have them installed on the wall by a qualified
personnel.
DO NOT install the satellite speakers on the wall by yourself to 
avoid unexpected damage from their falling off the wall due to 
incorrect installation or weakness in wall structure.
^ Care must be taken in selecting a location for speaker
installation on a wall. Injury to personnel or damage to 
equipment may result if the speakers installed interfere with 
daily activities.
Speaker Layout
Centre speaker
Front right speaker
Powered 
subwoofer
Front left 
speaker
Right surround 
speaker
Left surround 
speaker
TH-R1R3EU_00.book Page 15 Monday, March 28, 2005 9:23 PM