John Lewis JLBIDO911 - Manual (Page 36)

Cleaners that contain bleach should not be
used as they may dull the surface finishes.
Harsh abrasive and scourers should also be
avoided.
Cleaning the outside of
the appliance
Do not use abrasive cleaning materials e.g.
abrasive cream cleaners, wire wool pads or
scourers on painted or printed finishes as
damage may occur. Regularly wipe over the
control panel, control knobs, handles, doors
and appliance sides using a soft cloth and hot
soapy water. To prevent streaking, finish with
a soft cloth.
Stainless Steel cream cleaners are
abrasive and should be avoided as they
may dull the surface finish. Any spillage
on the stainless steel finish must be
wiped off immediately.
Removing and replacing
the wirework runners
1. Remove all shelves and furniture from the
oven.
2. Hold the wirework at the bottom, unclip
from the cavity side and gently pull
towards the centre of the oven.
3. Unhook the runner at the top and remove
from the cavity.
4. To replace the runners, hook the
wirework side runner into the cavity, slide
back and press into place.
Warning! Ensure the wirework
runners are firmly in position before
replacing the oven shelves.
Cleaning the shelves,
wire-work runners and
grill/oven furniture
All removable parts, except the grill pan
handle can be washed in the dishwasher.
The grill pan, grill pan grid, oven shelves and
wirework runners may be cleaned using a
soap impregnated steel wool pad. Soaking
first in hot soapy water will make cleaning
easier.
Cleaning inside the grill
and oven compartments
The sides and back of the grill/second oven
and main oven compartments are coated with
a special Stayclean coating. They should not
be cleaned manually.
The vitreous enamel main oven base and grill
compartment base can be cleaned using
normal oven cleaners with care. Ensure that
the manufacturers instructions are followed
and that all parts are well rinsed afterwards.
Warning! Aerosol cleaners must not
come into contact with elements, the
door seal, or any painted finishes as
this may cause damage.
Warning! Aerosol cleaners must not
be used on Stay-clean surfaces.
• To carry out the cleaning cycle, remove the
oven shelves and set the oven to CAtA
which is the cleaning setting.
• Press the Function selector until the
required setting is illuminated.
• The display will show CAtA and the heat
indicator will scroll until the required
temperature is reached.
36