JVC GR-DVX4 - Manual (Page 10)

10
EN
– – – – – 6 – – – – –
REC MODE
WIDE MODE
OFF
40X
SP
ZOOM
SELF-TIMER
GAIN UP
DIS
4
END
ON
AGC
OFF
FLASH
TO DATE / TIME MENU
TO SYSTEM MENU AUTO
– – – – – 6 – – – – –
SP SP LP
A M
PL
AY
OFF CAMER
A
5S
FOCUS
EXPOSURE
AUTO
OFF
OFF
AUTO
AUTO
W. BALANCE
FADER
/ WIPE
P. AE
/ EFFECT
END
0 FLASH ADJ.
TO MODE MENU 4
– – – – – 6 – – – – –
REC MODE
WIDE MODE OFF
40X
SP
ZOOM
SELF-TIMER
GAIN UP
DIS
END
ON
AGC
OFF
FLASH
TO DATE / TIME MENU
TO SYSTEM MENU AUTO
4
Recording Mode Setting
Set depending on your preference.
1 SELECT OPERATION MODE
Set the Operation Switch to “ ”. Then, set the Power
Switch to “ ” or “5S” while pressing down the
Lock Button. Open the LCD monitor fully or pull out
the viewfinder fully.
•The power lamp comes on and the camcorder is
turned on.
2
ACCESS RECORDING MENU
Press MENU/SET. The Recording Menu appears.
3 ACCESS MODE MENU
Move the highlight bar to “TO MODE MENU” by
rotating MENU/SET. Press it and the Mode Menu
appears.
4
SET RECORDING MODE
First move the highlight bar to “REC MODE” by
rotating MENU/SET. Press it and the parameter “SP”
or “LP” is highlighted. Select “SP” or “LP” by rotating
MENU/SET. Press it twice to exit from the Recording
Menu.
•Audio Dubbing is impossible on a tape recorded in
the LP mode.
•“LP” (Long Play) is more economical, providing
1.5 times the recording time.
NOTES:
● If the recording mode is switched during recording, the
playback picture will be blurred at the switching point.
● It is recommended that tapes recorded in the LP mode
on this camcorder be played back on this camcorder.
● During playback of a tape recorded on another
camcorder, blocks of noise may appear or there may be
momentary pauses in the sound.
Power lamp
Display
Recording mode indicator
MENU/SET Dial Power Switch
GETTING STARTED (cont.)
Mode Menu
Recording Menu
Lock Button
Operation Switch