JVC GR-DVX4 - Manual (Page 24)

24
EN
A M
,,,
,,,
,,
,,,,
,,,
,,,,
,,,,
,,,
,,,,
,,,
FULL
PHOTO
PL
AY
OFF CAMER
A
5S
Motor Drive Mode
Keeping SNAPSHOT pressed provides an effect similar to
serial photography. (The interval between the still images:
approx. 1 second.)
The flash fires only during the first snapshot (
੬
pg. 26).
To Remove The Shutter Sound . . .
.... when you don’t want to hear the shutter sound, set
BEEP/TALLY to “OFF” in the System Menu (
੬
pg. 28,
30). Though the sound is not heard from the speaker, it
is recorded on the tape.
NOTES:
● Even if “MULTI-4” or “MULTI-9” is engaged, Snapshot
recording will be performed in the FULL mode during
Digital Zoom. However, the flash will not fire.
● If Snapshot recording is not possible, “PHOTO” blinks
when SNAPSHOT is pressed.
● Even if Programme AE with special effects (
੬
pg. 34) is
engaged, certain modes of Programme AE with special
effects are disabled during Snapshot recording. In such a
case, the icon blinks.
● During playback as well, all Snapshot modes are
available. The shutter sound is not heard.
● To reduce the Red-Eye effect of the subject’s eyes when
the flash fires,
੬
pg. 26.
● When a cable or headphone set is connected to the AV
OUT connector, the shutter sound is not heard from the
speaker, however it is recorded onto the tape.
FULL
Snapshot mode with
no frame*
FRAME
Snapshot mode with
frame*
PIN-UP
Pin-Up mode*
MULTI-4
Multi-Analyser 4
MULTI-9
Multi-Analyser 9
* :There is a momentary
camera shutter-type
blackout together with
the sound effect of a
shutter closing, which
is recorded together
with the image.
RECORDING Advanced Features (cont.)
Snapshot
Use your camcorder like a regular camera and take a
snapshot, or several of them in succession.
SNAPSHOT MODE SELECTION
1
SELECT OPERATION MODE
Set the Operation Switch to “ ” or “ ”. Then, set
the Power Switch to “ ” while pressing down
the Lock Button. Pull out the viewfinder fully or open
the LCD monitor fully.
2 SELECT SNAPSHOT MODE
Choose the appropriate mode from among the 5
Snapshot modes by pressing SNAPSHOT MODE.
Press SNAPSHOT MODE as many times as necessary
until the desired snapshot mode indicator is displayed.
SNAPSHOT RECORDING
1 TAKE SNAPSHOT
Press SNAPSHOT.
•When the “ ” flash ready indicator is displayed,
the flash fires.
If you press during Record-Standby . . .
.... “PHOTO” appears and a still image will be
recorded for approx. 6 seconds, then the
camcorder re-enters the Record-Standby mode.
If you press during Recording . . .
.... “PHOTO” appears and a still image will be
recorded for approx. 5 seconds, then the normal
recording resumes.
Power Switch
Display
During snapshot
Power lamp
Operation Switch
SNAPSHOT Button
Lock Button
SNAPSHOT MODE
Button
Snapshot mode