JVC GR-DVX4 - Manual (Page 51)

EN
51
PLA
Y
O
FF
C
A
M
ER
A5S
T W
Digital Dubbing
It is also possible to copy recorded scenes from the
camcorder onto other video unit equipped with a DV
connector. Since a digital signal is sent, there is little if any
image or sound deterioration.
1
CONFIRM POWER-OFF STATUS
Make sure the camcorder’s power is off.
2 MAKE CONNECTIONS
Connect the camcorder to your video unit equipped
with a DV connector using the DV cable (optional) as
shown in the illustration.
3
START PLAYBACK
Press 4 to play back the source tape.
4 START RECORDING
While watching the playback on the monitor, engage
the DV connector-equipped video unit’s record mode
from the spot on the source tape you want to begin
recording.
NOTES:
● It is recommended to use the AC Power Adapter/
Charger as the power supply instead of the battery pack
(
੬
pg. 7).
● When using the camcorder for dubbing, be sure to use it
as a player. The camcorder's DV connector is only for
output.
● If a blank portion or disturbed image is played back on
the player during dubbing, the dubbing may stop so that
an unusual image is not dubbed.
● Even though the DV cable is connected correctly,
sometimes the image may not appear in step 3. If the
above occurs, turn off power and make connections
again.
● If “Playback Zoom” (
੬
pg. 54), “Playback Special
Effects” (
੬
pg. 55) or “Snapshot” is attempted during
playback, only the original playback image recorded on
the tape is output from the DV OUT connector.
● Be sure to use a DV cable with the core filter.
DV cable
(optional)
Video unit equipped
with DV connector
To DV IN
To DV OUT
Lock Button
PLAY (4)
STOP (5)
RM-V713U
(provided)
Power Switch
Open the
connector cover.