JVC HR-S8700EU - Manual (Page 31)

Masterpage:Right-NoTitle0
EN
31
Filename [HRS8700EU2.fm]
Page 31 July 20, 2000 4:31 pm
D
Set the tape speed.
Press SP/LP/EP ( p ).
● It is not possible to select EP mode if “COLOUR SYSTEM” is
set to “MESECAM” . (
੬
pg. 67 )
E
Set the VPS/PDC mode.
Press VPS/PDC to select “ON” or “OFF”.
● If “VPS/PDC ON” is displayed on the TV screen or “VPS/PDC”
is lit on the front display panel, VPS/PDC is set to ON.
● If “VPS/PDC OFF” is displayed on the TV screen or “VPS/PDC”
is not lit on the front display panel, VPS/PDC is set to OFF.
੬
“VPS/PDC Recording” on page 33.
F
Return to the normal screen.
Press PROG or OK. “PROGRAM COMPLETED” appears
on the TV screen for about 5 seconds, then the normal
screen appears. If “PROGRAM OVERLAPPED” appears
on the TV screen and “Err” on the front display panel, see
page 35.
● Repeat steps 1 – 6 for each additional programme.
G
Engage the recorder’s timer mode.
Press # (TIMER). The recorder turns off automatically
and “ # ” appears on the front display panel.
● To disengage the timer mode, press # (TIMER) again.
NOTES:
● To Change The Stop Time . . .
. . . press STOP +/– in step 3. You can compensate for
anticipated programme schedule delays.
● To Timer-Record Weekly Or Daily Serials . . .
. . . in step 3, press WEEKLY (number key “9”) for weekly
serials or DAILY (number key “8”) for daily serials (Monday —
Friday). Either “WEEKLY” or “DAILY” appears on the TV
screen. Pressing the button again makes the corresponding
indication disappear.
● You can programme this recorder to timer-record as many as 8
programmes. If you try to programme the recorder to record a
ninth, “PROGRAM FULL” appears on the TV screen and
“FULL” appears on the front display panel. To record the extra
programme, you must first cancel any unnecessary
programmes (
੬
pg. 34).
● It is not possible to timer-record a TV programme with a
S HOW V IEW number which starts with “0”.
Satellite Receiver Users
To timer-record a satellite broadcast using the S HOW V IEW
system:
A Perform “Satellite Receiver Control Setting” on page 17.
B Perform steps 1 – 7. In step 3, the front display panel
shows “L2” for the channel position. In step 5, you cannot
set “VPS/PDC” to “ON”.
C Leave the satellite receiver’s power on.
ATTENTION
Guide Program Number Set
“GUIDE PROG SET” appears after performing step 3 if the
Guide Program number for the S
HOW V IEW number you
entered has not been set.
If you want to set the Guide Program number for the satellite
broadcast station, press the number key “0” to change “TV
PROG” to “SAT”. Press
rt to input the channel position
number on which your recorder or satellite receiver receives
that station, then press OK or
e to set the Guide Program
number. The S HOW V IEW Program screen appears.
(Example)
To timer-record a ZDF
programme with the
S
HOW V IEW system.
* If your recorder receives ZDF on
the channel position 2, press OK
or
e
after entering “2”.
HRS8700EU2.fm Page 31 Thursday, July 20, 2000 4:31 PM