JVC HR-S8700EU - Manual (Page 37)

Masterpage:Right
EN
37
Filename [HRS8700EU2.fm]
Page 37 July 20, 2000 4:31 pm
REMOTE CONTROL FUNCTIONS
Remote A/B Code Switching
The remote control is capable of controlling two JVC video
recorders independently; one set to respond to the remote
control’s A code control signals and another set to respond to B
code control signals. The remote control is preset to send A code
signals because your video recorder is initially set to respond to
A code signals. You can easily modify your video recorder to
respond to B code signals.
A
Remove the power supply.
Unplug the end of the mains power cord from the mains
outlet.
B
Set the remote control code.
Press and hold VCR on the remote control for over 2
seconds, press the number key “2” and then press OK.
C
Re-supply the power.
Plug the end of the mains power cord into a mains outlet.
D
Turn on the recorder.
Press 1 on the remote control. The recorder will now
only respond to B code signals.
NOTE:
To set the recorder back to respond to A code signals, repeat the
same procedure as shown above, but in step 2, press the
number key “1” instead of “2”.
HRS8700EU2.fm Page 37 Thursday, July 20, 2000 4:31 PM