Jotul GF300 DV - Manual (Page 25)

25
Optional Blower # 155371
Figure 42 . Blower Kit Components
Figure 43 . Attach Snapstat and Blower Brackets.
„ „ „ „ „ THIS BLOWER MUST BE
ELECTRICALLY GROUNDED IN
ACCORDANCE WITH LOCAL CODES
OR, IN THE ABSENCE OF LOCAL
CODES, WITH THE CURRENT ANSI/
NFPA 70, NATIONAL ELECTRICAL
CODE OR CSA C22.1-CANADIAN
ELECTRICAL CODE.
„ „ „ „ „ THIS UNIT IS SUPPLIED WITH A
THREE-PRONG (GROUNDING)
PLUG FOR PROTECTION AGAINST
SHOCK HAZARD AND SHOULD BE
PLUGGED DIRECTLY INTO A
PROPERLY GROUNDED THREE-
PRONG RECEPTACLE. DO NOT
CUT OR REMOVE THE GROUNDING
PRONG FROM THE PLUG.
„ „ „ „ „ ALWAYS DISCONECT THE POWER
SUPPLY WHEN PERFORMING ANY
SERVICE ON THE FIREPLACE
INSERT.
Read these instructions before beginning the installation.
1. Unpack and check the contents of the blower kit.
The kit includes two Air Deflectors and two #7 x 1/2”
screws that will not be used with the GF 300 DV
Allagash stove. Contact your dealer if any damage is
evident or parts are missing. See fig. 42.
2. Install the Snapstat by sliding it all the way into the
slot in the bottom of the Snapstat Bracket as shown
in fig. 43.
3. Attach the Snapstat Bracket to the studs located in
the middle of the firebox floor using the two M6
hex nuts and a 10 mm wrench. See fig. 43.
4. Attach the Blower Bracket to the stove using the
two M6 flange head hex bolts as shown in fig. 43.
5. Install the Blower with the duct openings oriented
up and to the rear. See fig. 44. Feed the snapstat
wire harness through the bracket opening and
secure the blower to the bracket with the
wingscrew. Route the controls wire harness over to
the female quickconnector already installed in the
stove.
6. Attach either Snapstat wire connector to either
Snapstat terminal. See fig. 44.
7. Connect the male Control Switch connector to the
female control switch wire harness already installed
in the stove. See fig. 44.
8. Connect power cord to outlet.
Contents
1. Blower
2. Mounting Bracket
3. Snapstat Wire Harness
4. Control Switch Wire Harness
5. Snapstat
6. Snapstat Bracket
7. M6 x 1 x 20 Flange Nuts (2)
8. M6 x 12 Wingscrew
5
7
2
8 4
3
1
6
Tools Required
• 10 mm wrench
Snapstat
Bracket
Blower Bracket
Hex Head
Flange Bolts
Hex Head
Flange Nuts