Jotul GF300 DV - Manual (Page 27)

27
Figure 47. Brick Kit Contents
Optional Antique Brick Kit
# 155370
Figure 48.
Disengage the
compression latches
to remove the glass
frame.
Figure 50. Install Side Panel
Figure 49. Install Lower Rear Panel
CAUTION!
THE BRICK PANELS AND LOG PARTS ARE
EXTREMELY FRAGILE. HANDLE WITH CARE.
Read these instructions before beginning the installation.
1. Remove the Top Plate. Simply lift it up off of the
stove body. It is not fastened.
2. Remove the Glass Frame. Disengage the two com-
pression latches located at the top of the firebox and
lift the glass frame up and off of the stove. See fig. 48.
3. If installed, remove the Logset. These parts are not
fastened. Simply lift them out of the firebox. You do
not have to remove the embers.
4. Install the Lower Rear Panel. Position it up against
the back wall, resting on the burner skirt. Fig. 49.
5. Install a Side Panel. Tilt the panel, bottom edge first,
into position against the side wall. The panel will
stand on its own against the wall, fitting snugly
between the rear panel and the front wall of the
firebox. Fig. 50.
6. Install the Upper Rear Panel. Simply rest it on the
other two panels. Fig. 51.
7. Install the other Side Panel.
8. Reinstall the Logset. Refer to the Owner’s Manual if
necessary. BE CERTAIN THAT NO EMBER STONES ARE
BLOCKING THE PILOT ASSEMBLY OPENING. Refer to fig. 36.
9. Replace the Glass Frame. Slide the frame down the slot
in the front of the firebox. Be sure to push the frame into
the slot in the bottom to ensure it is fully seated. The
gasket at the top of the frame should be flush with the top
of the firebox.
Pull the compression latches out to engage with the top lip
of the glass frame.
10. Replace the Top Plate.
Figure 51. Install Upper Rear Panel
Lower Rear Panel
220744
Right Panel
220747
Upper Rear Panel
220745
Left Panel
220746